Domo MY TEA DELUXE Manual De Instrucciones página 35

www.domo-elektro.be
USE
1. To fill the kettle with water, take it off of the base. Then open the lid of the water
tank by pressing on the button.
2. Fill the water tank with your desired quantity and close the lid again.
3. Pay attention that you draw enough water so that the water level lies between the
MIN & MAX on the water tank. If you do not do this, the device will shut off
before the water is boiled.
NOTE: Make sure the lid is closed properly before plugging the cord into the
socket.
4. Place the kettle on the base.
5. Place a cup on the drip tray and make sure it's located right below the spout.
NOTE: the used cup must be 50 ml bigger than the desired amount of water. Also
make sure the cup is in the right spot before turning the device on.
6. Set the control button to the desired amount of water. The smallest amount of
water is 150 ml, the biggest is 300 ml. Make sure the cup is 50 ml bigger than the
desired amount of water.
7. Plug the cord into the power socket and turn the device on using the on/off switch.
The switch and the water tank will light up and the water will start to boil.
NOTE: Make sure the cord is not blocked in any way and the lid is properly
closed.
8. After about 45 seconds, the water will boil, the device will turn off automatically
and one cup of steaming hot water will pour out of the spout. Wait until all the
water runs through the spout before removing the cup from the drip tray. You can
stop the boilinprocess at any time by pressing the stop button. The on switch will
automatically switch off. NOTE: the water running through the spout is boiling
warm, never touch it to prevent burn wounds from forming.
dry boil protection
• Always turn off the device and remove the plug from the socket. Also let the
device cool down for a while before cleaning it.
• Never immerse the kettle, base or plug in water or any other kind of liquid.
• Clean the outside of the device with a soft, damp cloth and mild detergent. Never
use a biting cleanser.
• attention: never use chemicals, steel, wood or rough cleaning devices to clean the
outside of the device, as this could damage the finish.
• When you are not using the device, you can store away the cord and plug below
the base.
emptying the kettle
When the device is fully cooled, remove the plug from the socket.
Open up the water tank using the button.
Keep the kettle above your sink.
35
DO497WK