Forch 5331 1 18 1 Manual Original página 17

Battery charge indicator
The green LEDs on the battery charge indicator in-
dicate the state of charge of the battery. For safety
reasons, it is only possible to check the state of
charge when the power tool is not in operation.
Press the button for the battery charge indicator
or to show the state of charge. This is also pos-
sible when the battery is removed.
If no LED lights up after pressing the button for the
battery charge indicator, then the battery is defect-
ive and must be replaced.
Battery model GBA 18V...
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Battery model ProCORE18V...
LEDs
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Changing the tool (see figure A)
Remove the battery from the power tool be-
u
fore carrying out work on the power tool
(e.g. maintenance, changing tool, etc.). The
battery should also be removed for transport
and storage. There is risk of injury from unin-
tentionally pressing the on/off switch.
Open the keyless chuck (2) by turning it in the dir-
ection of rotation ➊ until the tool can be inserted.
Insert the tool.
Firmly tighten the keyless chuck (2) by turning it by
hand in the direction of rotation ➋. This will auto-
matically lock the drill chuck.
1 609 92A 7MF • 25.11.22
English
English
Capacity
60−100 %
30−60 %
5−30 %
0−5 %
English
Capacity
80−100 %
60−80 %
40−60 %
20−40 %
5−20 %
0−5 %
English
Dust/Chip Extraction
Dust from materials such as lead-containing coat-
ings, some wood types, minerals and metal can be
harmful to one's health. Touching or breathing-in
the dust can cause allergic reactions and/or lead
to respiratory infections of the user or bystanders.
Certain dust, such as oak or beech dust, is con-
sidered carcinogenic, especially in connection with
wood-treatment additives (chromate, wood preser-
vative). Materials containing asbestos may only be
worked by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class res-
pirator.
Observe the relevant regulations in your country
for the materials to be worked.
Avoid dust accumulation at the workplace.
u
Dust can easily ignite.
Operation
English
Starting Operation
English
Inserting the battery
English
Note: The use of batteries unsuitable for your
power tool can lead to malfunctions or damage to
the power tool.
Set the rotational direction switch (9) to the middle
position to avoid unintentionally switching it on. In-
sert the charged battery (6) into the handle until
you feel it engage and it is flush with the handle.
Setting the rotational direction (see figure B)
The rotational direction switch (9) is used to
change the rotational direction of the power tool.
However, this is not possible while the on/off
switch (10) is being pressed.
Right rotation: To drill and to drive in screws,
press the rotational direction switch (9) through to
the left stop.
Left rotation: To loosen and unscrew screws and
nuts, press the rotational direction switch (9)
through to the left stop.
Setting the Operating Mode
Drilling
Set the torque presetting ring (3) to the
"drilling" symbol.
English
English
English
English | 17