Publicidad
Idiomas disponibles
Idiomas disponibles
accessory (G-5) fixing it with the wall
screw (J). Repeat this step in the 4 holes.
-
Attach the internal fittings (G-4) and the 4
front fittings (G-3) to the unit with the
screws (G-2). Then place the trims (G-1) so
that the screws are not visible.
-
Insert the internal fittings (G-4) to the
external fittings (G-5) on the wall and fix
them with the fixing screws (H) so that the
unit is securely fastened.
-
Be sure to remove all packaging carefully
so as not to lose any of the parts.
-
Carefully follow the assembly instructions
to assemble the unit correctly.
-
When using for the first time, leave it on for
2 to 3 hours in a ventilated space to get rid
of the new smell.
Continuous heat mode:
-
If we press the power button (E), the
device will go into continuous heat mode
and will emit heat until we press the button
(E) again, thus turning off the device.
Towel warmer mode:
-
After switching on the device, press the
timer button (D).
-
You can press the button (D) as many
times as you wish up to a maximum of 8h.
-
After the set time the device will switch
itself off.
-
NOTE: The LED display (C) always shows
the room temperature.
-
Switch the unit off using the on/off button
(E).
-
Unplug the unit from the mains.
-
Wait for the unit to cool down.
-
WARNING: Some parts of the appliance
can become very hot, so be careful not to
touch it until it has cooled down.
-
The appliance is equipped with a thermal
safety device that protects the appliance
from overheating.
-
When the appliance switches on and off
alternately, and this is not due to the
action of the room thermostat, check
that there is no obstacle preventing or
hindering the normal air inlet or outlet.
-
If the appliance switches itself off and
does not switch back on, unplug it from
the mains and wait about 15 minutes
before switching it on again. If it still
does not work, contact an authorized
service center.
-
Always switch off the device and allow it
to cool down before cleaning.
-
Clean the device with a soft damp cloth
impregnated with a few drops of
detergent and dry it afterwards.
-
Do not use abrasive material to avoid
damaging the surface.
-
Do not use solvents, or products with an
acid or basic pH factor such as bleach,
or abrasive products, to clean the
appliance.
-
Do not immerse the appliance in water
or any other liquid, nor put it under the
tap.
Publicidad
