Silverline 802165 Manual De Instrucciones página 10

GB
Troubleshooting
Problem Possible cause Solution
No power Check power supply
No function when On/Off Button (2
& 3) is operated
Defective On/Off Button Replace the On/Off Trigger Switch at an authorised Silverline service centre
Loose spindle locking nut Ensure that the blade is correctly fastened to the spindle, see 'Replacing the cutting disk'
Cutting Disk (5) is making strange
Check the Cutting Disk is seated on the inner flange correctly so that it runs safe and true,
The Cutting Disk is not seated on the inner flange correctly
noises/vibrating/not performing
see 'Replacing the cutting disk'
straight cuts
The Cutting Disk is too worn/warped from excessive use Replace the Cutting Disk, see 'Replacing the cutting disk'
Insufficient amount of water in the Water Sump (1) Refill the Water Sump
The Cutting Disk is wearing exces-
sively and a burning smell is being
produced'
Cutting Disk is too worn to effectively dissipate heat Check and replace the Cutting Disk, see 'Replacing the cutting disk'
10