ERROR CODES
E01
Possible cable fault
E02
Motor failure
E03
No speed sensor signal
E05
Possible motor overload
E06
Calibration error
E07
Safety key
E08
Burned control board
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
Connect the wire between top controller and
console.
Check the motor wires. Replace the motor if
necessary.
Check the position or replace the speed
sensor.
a.- Lubricate the belt.
b.- Check that the motor is not burned.
c.- Check that the control board is not burned.
Change the control board.
Attach the safety key correctly.
Change the control board.
12