NISBETS ESSENTIALS CU759 Manual De Instrucciones página 5

Emptying the Appliance
Drain the appliance by using the tap to empty.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The Safety Cut-out switch is located on the
underside of the appliance.
To reset the appliance:
1. Empty the appliance and allow to cool.
2. Press the reset button until it clicks.
WARNING: Ensure the appliance has cooled down
and is empty before resetting the switch, as it
may need to be tipped slightly to gain access to
the switch.
3. The appliance is now reset and can be used as
normal.
Cleaning, Care &
Maintenance
• Always turn off and disconnect the appliance
from the power supply before cleaning and
descaling.
• Let the appliance cool down then empty.
• Do not use jet/pressure washers to clean the
appliance.
• Use soapy water and a damp cloth to clean the
exterior of the appliance.
• Dry thoroughly after cleaning.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not working
Indicator light comes
on but water does not
reach temperature
The tap is leaking
CU759_ML_A5_v1_20230209.indb 5 CU759_ML_A5_v1_20230209.indb 5
Descaling
For the best water quality, Nisbets Essentials
recommend that a water filter is installed to the
mains water supply, particularly in hard water areas.
Doing so will reduce the build up of limescale and
contaminants in the water tank thus maintaining
energy efficiency and prolonging the life of the
appliance.
To de-scale the appliance:
1. Pour a solution of de-scaler and water into the
2. Brush the interior gently with a soft bristled
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back
5. The appliance is now ready for use.
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Thermal fuse has activated
Thermostat fault
The tap has become loose
appliance.
brush.
On to flush out the system. Flush out the system
thoroughly to remove any de-scaler residue.
Note: Use a suitable de-scaler and always follow
the instructions on the container.
Nisbets Essentials recommend that this appliance
is de-scaled every 3 months or more often in hard
water areas.
IMPORTANT: Failure to de-scale or maintain will
invalidate your guarantee.
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Reset Thermal fuse
Consult a qualified technician
Tighten the tap handle
EN
5
2023/2/9 15:44 2023/2/9 15:44