Maruyama MS0835W Manual Del Usuario página 6

5
CAUTION
Without water or chemicals in the tank, the pump will break down. Never run the pump dry.
Perform priming.Push priming
1
pump installed in front of the
carburetor several times slowly,
and confirm that fuel fills the
priming pump and returns to the
tank through the clear return line.
2 Fully close the choke. (In hot
weather or when engine is hot,
the choke should be partly open
or fully open.)
3 Move throttle lever to medium-
and low-speed position.
Turn the handle of the pressure control valve until there is
1
position).
STARTING
When engine is started and when pump starts suction.
HERBICIDE
When engine is started and when pump starts suction.
killer, etc.)
INSECTICIDE
Normal spraying work
HIGH PRESSURE
hose than standard is used.
2 After confirming proper pump and spray operation in the
machine, move the throttle lever to high-speed position.
CAUTION
W h e n s e t t i n g t h e p r e s s u r e c o n t r o l va l ve h a n d l e t o
"HIGH PRESSURE" position of pressure control valve handle,
engine revolutions increase as pressure decreases. When
position, use at a position little bit back from full open
throttle.
When opening ball cock, chemicals will be sprayed from
3
nozzle in a mist.
Operating instructions
Operation
Set handle of pressure control valve
4
at "STARTING" position.
5 Engine will start.
After pulling starting rope gently by two or three times,
pull it hard to start the engine.
[Pulling method for starting rope]
1.Grasp starting rope tight with right hand.
2.Hold chemical tank with left hand.
3.Pull starting rope slowly until resistance is felt.
4.Pull starting rope straight from entrance of starter.
5.Do not pull starting rope to the end.
6.Do not release the starter rope handle when rope
is extended. Allow the recoil to rewind the rope
gradually.
CAUTION
Throttle lever
If the engine does not start by repeated action, try
pulling the rope after fully opening the choke.
If the engine still does not start, refer to page 7.
6 Return choke slowly.
1
2 Return throttle lever to low speed.
3 Push stop button to stop engine.
Stop
Push
Stop button
Throttle lever
STARTING