Publicidad
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radioexempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada,
le présent émetteur radio peut fonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur)
approuvé pour l'émetteur par Industrie Canada. Dans
le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il
faut choisir le type d'antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
This equipment should be installed and operated with a
minimum distance 20cm between the radiator and
your body.
Cet équipement doit être installé et utilisé à une
distance minimale de
20 cm entre le radiateur et votre corps.
KC
Class B: This device is intended for mainly home use
(Class B) and may be used in all areas.
B급기기: 이 기기는 가정용(B급)
전자파적합기기로써 주로 가정에서 사용하는
것을 목적으로 하며,모든 지역에서 사용할 수
있습니다.
Safety Instruction
These instructions are intended to ensure that the user
can use the product correctly to avoid danger or
property loss.
Laws and Regulations
The device should be used in compliance with local
laws, electrical safety regulations, and fire prevention
regulations.
Electricity
In the use of the product, you must be in strict
compliance with the electrical safety regulations of the
nation and region. The equipment shall not be exposed
to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the equipment.
Provide a surge suppressor at the inlet opening of the
equipment under special conditions such as the
mountain top, iron tower, and forest. CAUTION: To
reduce the risk of fire, replace only with the same type
and rating of fuse.
Battery
Do not ingest battery. Chemical burn hazard! This
product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause
severe internal burns in just 2 hours and can lead to
death. Keep new and used batteries away from
children. If the battery compartment does not close
securely, stop using the product and keep it away from
children. If you think batteries might have been
swallowed or placed inside any part of the body, seek
immediate medical attention. CAUTION: Risk of
explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
ATTENTION: IL Y A RISQUE D'EXPLOSION SI LA BATTERIE
EST REMPLACÉE PAR UNE BATTERIE DE TYPE
INCORRECT. METTRE AU REBUT LES BATTERIES
USAGÉES CONFORMÉMENT AUX INSTRUCTIONS.
Improper replacement of the battery with an incorrect
type may defeat a safeguard (for example, in the case
of some lithium battery types). Do not dispose of the
battery into fire or a hot oven, or mechanically crush or
cut the battery, which may result in an explosion. Do
not leave the battery in an extremely high temperature
surrounding environment, which may result in an
explosion or the leakage of flammable liquid or gas. Do
not subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of
flammable liquid or gas. + identifies the positive
terminal(s) of equipment which is used with, or
generates direct current. - identifies the negative
terminal(s) of equipment which is used with, or
generates direct current.
Fire Prevention
No naked flame sources, such as lighted candles,
should be placed on the equipment. The serial port of
the equipment is used for debugging only.
Hot Surface Prevention
4
CAUTION: Hot parts! Burned
fingers when handling the parts.
Publicidad
