Hilti SID 4R-22 Manual De Instrucciones Original página 16

5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery. → page 8
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Changing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
1. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
2. To insert the accessory tool push it into the tool holder as far as it will
go, until the locking sleeve engages with an audible click. Check that the
accessory tool is held securely.
3. To remove the accessory tool, pull the locking sleeve forward and hold
it in this position.
4. Pull the accessory tool out of the tool holder and release the locking
sleeve.
12 English
2
2373959
*2373959*