GE PNRQ15RBL Manual Del Propietario Y Instalación página 15

FAUCET ASSEMBLY (cont.)
OPTIONAL ONE-PERSON FAUCET
TUBING INSTALLATION
1. From under the sink, gather the 1/4" drain line
(black), 3/8" drain line (black) and 3/8" outlet tube
(blue banded) in one hand with the drain tubes
the same length and the outlet tube offset
approximately 6 inches.
2. Wrap a rubber band around all 3 tubes.
3. Insert a typical No. 2 pencil through the rubber
band location.
4. Rotate the pencil down until it is in line with the
tubing and push up through the mounting hole.
Release the grip on the pencil and the tubes
will remain in position for easier faucet
connection.
Installation Instructions
15
INSTALL THE BATTERY
1. Remove the lens cover from the faucet
base. Grip it from both sides and pull
forward.
2. Install one CR2032 3V battery with the
"+" side DOWN into the battery tray. Slide
the battery tray completely back into the
base.
Faucet base
Lens cover
3. Each light will illuminate in sequence
twice. The OK (green) light or Filter
(amber) light may stay on for a few
extra seconds. If you want to reinitiate
the start-up sequence, remove the battery
for 90 seconds so the electronics can fully
reset; then put the battery back in.
4. The OK (green) light will normally flash
one time per second when dispensing
water. If the system needs service, the
Filter or R.O. (amber) lights will flash one
time per second while dispensing and will
randomly flash when not in use.
NOTE: For lights to change between
OK and R.O., the system must detect
a change in the filtering process for
25 consecutive seconds. For example,
if the system was showing that service
was needed, it will take 25 seconds of
consecutive filtering for the system to
confirm the correct service changes
were made.
FOR FILTER CHANGE: Replace the battery
when changing the filter. Remove the
used battery and wait 90 seconds before
installing the new battery to ensure the
proper electronics are reset for the next
6 months.
Battery "+"side down