Publicidad
19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
20. If you do not use iron, even for a short time, turn off the options of steam
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Iron must be used at a stable even surface and this can only be disposed of.
24. Do not fill the water tank with chemicals, perfumes or descaling substance.
DESCRIPTION OF DEVICE
A. The water inlet hole
B. Steam button
C. Power Cord
D. Rotary cable gland
E. Thermostat knob - temperature contro
F. Thermostat indicator light
G. Water tank
H. Steel soleplate
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics. This
is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of fabric.
GARMENT
FABRIC
THERMOSTAT
LABEL
TYPE
REGULATION
·
synthetic
low temperature
··
silk - wool
medium temperature
···
Cotton - linen
high temperature
Fabric not to be ironed
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
STEAM IRONING
Check that the plug is disconnected from the socket. Raise the tip of the iron to help the water enter the opening without overflowing.
Slowly pour the water into the reservoir using the special measure and taking care not to go over the maximum, indicated by
"MAX"Place the iron in a vertical position. Plug it to the electricity.
Warning: When you ironing, the thermostat control light turns on from time to time, this means that the selected temperature is
maintained at a constant level. If you decrease temperature, do not begin ironing again until the thermostat light does not light up.
Warning: The steam function can be used only at the highest temperatures. Do not use the button when thermostat indicator lits. You
can return to the vertical ironing only if the pilot light goes out.
PROCEDURE AFTER IRONING
Disconnect the plug of the iron from the socket. Empty the reservoir by turning the iron upside down and gently shaking it. Leave the
iron to cool down completely.
ENGLISH
ADVICE FOR GOOD IRONING
1. We recommend using the lowest temperatures with fabrics that have unusual finishes (sequins, embroidery, flush, etc.).
2. If the fabric is mixed (e.g. 40% cotton 60% synthetics), set the thermostat to the temperature of the fibre requiring the lower
4
Publicidad
