Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
•
Do not look in the light or see the source of light
directly.
Pull the switch trigger to turn on the light. The lamp
keeps on lighting while the switch trigger is being pulled.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Auto-stop mechanism
When the battery capacity gets low, the tool stops
automatically to prevent lack of fastening torque. In that
case, charge the battery cartridge or use a charged
battery cartridge.
Indicating low battery charge
When the trigger is pulled and front lamp blinks several
times, that shows the battery capacity gets low and
immediately before the auto - stop mechanism works.
Reversing switch action
A
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
•
When not operating the tool, always set the
reversing switch lever to the neutral position.
B
1
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit or
socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1
► 1. Bit 2. Sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
•
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
5 ENGLISH
9 mm
(3/8")
2
Publicidad
