Descargar Imprimir esta página

Hart HLPM03 Manual Del Operador página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.
POSSIBLE CAUSE
Handle adjustment knobs and/or
handle lock levers are not secured.
Battery is low in charge.
Start key not installed.
Handle assembly is not in operating
position.
Mower is in a vertical position or tilted
at an angle greater than 45º.
The metal lock(s) on the grass catcher
or mulching plug is not fully seated
in the slot(s) on the mower housing.
Lawn is rough or cutting height not
set properly.
Wet grass clippings sticking to the
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Cutting height set too low.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low.
13 – English
SOLUTION
Make sure handle adjustment knobs are
fully seated and handle lock levers are
fully locked.
Charge the battery.
Install start key.
Make sure the handle assembly is in the
operating position.
Place the mower in a horizontal position.
Gently push down on the metal lock(s) to
ensure it is fully seated in the slot(s).
Adjust the cutting height.
Wait until the grass dries before mowing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor, remove start key and bat-
tery. Inspect for damage. Have repaired
by an authorized service center before
restarting.
Raise the cutting height.

Publicidad

loading