Publicidad
Idiomas disponibles
Idiomas disponibles
18
www.aeg.com
Problem
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Some specific surfaces in‐
side the fridge compartment
are warmer at some times.
Temperature setting LEDs
flash at the same time.
Possible cause
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The Frostmatic function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Frostmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
An error has occurred in
measuring the temperature.
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off Frostmatic func‐
tion manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
This is a normal state.
Contact the nearest Author‐
ised Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.
Publicidad
