Bombard TYPHOON 285 Manual Del Propietário página 30

Activate all valves into inflation position.
Fit the hose to the foot-pump.
To inflate your boat properly, the bottom side of the foot-
pump must rest on a flat ground
rapidly.
WARNING
A - INFLATE THE INFLATABLE FLOOR (TYPHOON Aero only)
1. Activate the standard valve into inflating position.
2. Inflate in position A (cap inserted) until it becomes difficult to operate.
3. Finish inflation in position B (cap removed) until you reach correct pressure (800 mb–11.6
PSI)
B - INFLATE THE MAIN BUOYANCY TUBE AND THE KEEL
CAUTION
Inflate the main buoyancy tube and the keel (TYPHOON Aero :in position A - cap inserted) until
it becomes difficult to operate.(correct pressure = 240 mb / 3.48 PSI), reefer to PRESSURE
section making sure that each compartment is equal. When correctly inflated, the
compartments bulkheads are not visible.
NEVER COMPLETELY
COMPARTMENT TO FULL
PRESSURE IF OTHER
COMPARTMENTS ARE
TOTALLY DEFLATED
Inflation is over: fit the valve caps tight (clockwise).
NOTICE :
INFLATION
.
Pump evenly to inflate
DO NOT USE A COMPRESSOR OR A BOTTLE OF COMPRESSED AIR
MAXIMUM PRESSURE IN THE MAIN BUOYANCY TUBE
AND IN THE KEEL : 240 MBARS (3.4 PSI)
TYPHOON AERO : NEVER USE POSITION B TO INFLATE THE MAIN
TUBE . THERE WOULD BE A RISK OF BURST.
INFLATE A
1
2
A slight air-leak before screwing the valve caps is normal.
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
50 %
50 %
100 %
100 %
8 / 10
A
50 %
100 %