A 220~240 Volt /50 Hz AC only 10 ampere fused and properly earthed
electrical supply is required. It is recommended that a separate circuit
serving only this appliance be provided. Use a receptacle which cannot be
turned off with a switch or pull chain. Do not use an extension cord.
Before performing any type of installation, disconnect the refrigerator from
the electrical source. When you are finished, connect the refrigerator to
the electrical source and reset the control to the desired setting.
2.6 Leveling
If the refrigerator is not leveled during installation. The doors may not close or
seal properly, causing cooling, frost, or moisture problems. It is very important of
the refrigerator to be level in order to function properly.
To level your refrigerator you may either turn the level leg clockwise to raise that
side to the refrigerator or turn counter – clockwise to lower that side.
NOTE: Having someone push against the top of the refrigerator take some
weight off the leveling leg. This makes it easier to adjust the leveling leg.
2.7 Position of the door
1) Disassemble the screws behind the fixed roof with cross-slot screwdriver
and remove the cover from the refrigerator.
2) Remove the screws fixed the top-hinge
Replace the top-hinge.
with cross-slot screwdriver.
15
V.1