Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting/removing the battery pack
Inserting the battery pack
♦
Set the rotation direction switch 2 to the middle
position (lock). Snap the battery pack 8 into
the handle.
Removing the battery pack
♦
Press the release button 9 and remove the
battery pack 8.
Checking the battery charge level
Press the battery charge level button w to
♦
check the charge level of the battery. The
status/remaining charge will be shown on
the battery display LED q as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the belt clip
♦
Loosen the fixing screw
Phillips screwdriver (not supplied).
Hold the corresponding hole of the belt clip 3
♦
over that of the screw thread.
♦
Tighten the fixing screw
Switching on/off
Switching on
Press and hold the ON/OFF switch 7 to start
♦
the tool.
The LED work light 4 lights up when the ON/
OFF switch 7 is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
Release the ON/OFF switch 7 to switch off the
♦
appliance.
50
GB │ MT
■
│
using a standard
3a
.
3a
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque preselection button 6 to select
the required torque incrementally. The selected
torque is shown on the torque display 5.
♦
Pressing the ON/OFF switch 7 lightly yields a
low speed. Increasing the pressure increases
the speed/tightening torque.
♦
The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
►
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
►
The integrated motor brake ensures rapid
stoppage.
ATTENTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
♦
Change the direction of rotation by pushing the
rotation direction switch 2 to the right or left.
Inserting/replacing tools
♦
Pull the locking collar
suitable tool into the tool holder 1.
♦
Pull the locking collar
remove the tool.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the tool.
to the front. Insert a
1a
to the front again to
1a
PDSSAP 20-Li B3
Publicidad
