Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Moving Machine By Hand
WARNING! Make no adjustments without:
•
the engine stopped,
•
the park brake activated
IMPORTANT INFORMATION
push the mower, engage the hydro bypass
levers on both sides, pull both steering / park
brake controls inwards and push machine.
When pushing or pulling the mower, engage the
EZT bypass linkages. The EZT bypass linkages
are located on the rear of the frame, below the
rear engine guard.
1. Raise the deck into the highest cutting
position.
2. Move the steering / park brake controls
inwards to the neutral position.
3. Pull the EZT bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
4. To reengage the EZT's to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving
slowly up the ramps. DO NOT LIFT! The machine
is not intended to be lifted by hand.
20
To manually
WARNING! Bypass linkages are located
close to the muffler. To prevent burns, the
engine should be shut off and allowed to cool
before the bypass linkage levers are handled.
WARNING! Use more caution when
loading the machine into a truck or trailer using
ramps. There is the possibility of dangerous
injury or death if the machine falls off the
ramps.
Publicidad
