Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 5a
Figure 6a
8. Wiring.
• Remove Control Module cover by gently prying
the cover off of the retention tabs on sides.
CAUTION: Control board has sensitive electronic
components.
• Install 1/2" trade-size cable clasp connector
(not included) in knockout and insert house
power cable
• Connect house power wires as shown
(Figure 7).
• Adjust the thermostat as desired from 60°F
(16°C) to 120°F (49°C) (105°F [41°C]
recommended setting)
• Connect the male solar plug to female plug
on Control Module and connect the male
plug on Control Module to the female
motor plug
• Each Dual-Powered Roof Vent unit must have
its own Control Module
9. OPERATION.
The vent will operate when sufficient solar light is
on the solar panel regardless of thermostat setting
or house power connection for efficient exhaust of
attic heat and humidity year-round.
Note: In the unlikely event that parts and/or
accessories are missing or this product does
not operate correctly, contact Master Flow
Technical Services at 1-800-211-9612 or
WarrantyLLBP@gaf.com. Do NOT return to
retailers or distributors.
Note: Nylok
is a registered trademark of Nylok
®
Corporation, LLC.
Figure 5b
Figure 6b
®
INSTRUCTIONS
Model: ERVHYBRID
Figure 5c
Figure 7
THERMOSTAT
HOT
NEUTRAL
GROUND
GROUND
SCREW
Figure 8
We protect what matters mos t
Figure 5d
CONTROL BOARD
™
Publicidad
