Vox AC30HW60 Manual De Usuario página 8

EXTERNAL SP:.This.speaker.jack.will.mute.(disconnect).the.internal.speakers.and.you.can.hook.up.ei-
ther.a.16.Ohm.or.8.Ohm.cabinet..Be.sure.to.set.the.IMPEDANCE.SELECT.switch.accordingly..(See."IM-
PEDANCE.SELECT.Switch")
AC30HW
1
The.AC30HW.internal.speakers.are.connected.via.a.speaker.jack.plug,.they.are.wired.for.16.Ohms..You.
can.connect.another.16.ohm.cabinet.and.run.this.in.parallel.with.the.internal.speakers..If.you.want.to.dis-
connect.the.internal.speakers.simply.unplug.the.jack..Be.sure.to.set.the.IMPEDANCE.SELECT.switch.ac-
cordingly..(See."IMPEDANCE.SELECT.Switch")
WARNING!. To.ensure.that.your.system.works.correctly,.you.must.observe.the.following.points.
a). Don't.use.an.extension.cabinet.whose.impedance.is.anything.other.than.16.ohms.
b). Don't.connect.a.speaker.whose.rated.input.capacity.is.less.than.30.watts.(for.AC30HW).or.15.watts.
(AC15HW)..The.speaker.may.be.destroyed.if.you.ignore.this.caution—not.recommended!
c). You.must.use.a.speaker.cable.to.connect.an.external.speaker..Don't.use.a.shielded.cable.like.the.one.
you.use.to.connect.a.guitar.to.an.amp.
d). You. must. turn. off. the. power. before. connecting. the. speaker. cable.. Connecting. the. cable. while. the.
power.is.turned.on.may.damage.your.amp.
NOTE!. It.is.recommended.that.all.audio.cables.(with.the.exception.of.the.speaker.lead),.used.to.con-
nect.to.the.AC30HW/AC15HW.are.of.a.high.quality,.screened.type..These.should.not.exceed.10.metres.
in.length..Always.use.a.non-screened.VOX.approved.speaker.lead.with.the.AC30HW/AC15HW.Amplifier.
and.extension.cabinets.
2. IMPEDANCE SELECT switch
16 OHMS:.Combos.allow.for.the.following.configurations:
a). Set.it.to.this.if.you.use.the.internal.speakers.only.
b). Set.it.to.this.if.you.connect.an.external.16.Ohm.speaker.cabinet.through.the.External.jack.(internal.
speakers.disconnected).
8 OHMS:.Combos.allow.for.the.following.configurations:
a). Set.it.to.this.if.you.connect.an.extension.cabinet..You'll.be.running.the.internal.and.external.speakers.
in.parallel..The.impedance.of.the.extension.cabinet.must.be.16.Ohms.
b). Set. it. to. this. if. you. connect. an. external. 8. ohm. speaker. cabinet. through. the. External. jack. (internal.
speakers.disconnected).
3. FOOT SWITCH jack
This.is.where.you.connect.the.included.Foot.Switch.(VFS1).to.switch.between.HOT.and.COOL.modes.on.
the.TOP.BOOST.Channel.(HOT.Mode.must.be.engaged.on.the.control.panel.for.the.Foot.Switch.to.oper-
ate)
4. MAINS INPUT connector
This.is.where.the.supplied,.detachable.Mains.(power).cord.is.connected..The.specific.mains.input.voltage.
rating.that.your.amplifier.needs.to.run.at.is.located.on.the.rear.panel.of.your.amplifier..Before.making.any.
connections.or.powering.up.the.amplifier,.make.sure.the.correct.voltage.is.set..If.you.have.any.doubt,.re-
fer.to.your.local.VOX.dealer.
2 3
8
4