Anker SOLIX Solarbank E1600 Manual Del Usuario página 7

Waterproof rating IP65
Warranty 10 years
*Considering the power and voltage fluctuation of the solar panels, and to match the operating voltage of the micro inverter,
it is recommended that the total PV Voc (open circuit voltage) be between 30-55V.
Safety Information
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before you use this product. Do not make any changes or create settings that are not
described in this manual. If physical injury, loss of data, or damage is caused by failure to follow instructions,
the warranty does not apply.
• To reduce the risk of injury, close supervision is necessary when the product is used near children.
• Do not put fingers or hands into the product.
• Use of an attachment not recommended or sold by the product manufacturer may result in a risk of
fire, electric shock, or injury to persons.
• To reduce risk of damage to the electric plug and cord, pull the plug rather than the cord when
disconnecting the product.
• Do not use the product in excess of its output rating. Overload outputs above the rating may result
in a risk of fire or injury to persons.
• Do not use the product or attachment that is damaged or modified. Damaged or modified batteries
may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
• Do not operate the product with a damaged cord or plug, or a damaged output cable.
• Do not disassemble the product. Take it to a qualified service person when service or repair is
required. Incorrect reassembly may result in a risk of fire or electric shock.
• Do not expose the product to fire or high temperatures. Exposure to fire or temperatures above
130°C may cause an explosion.
• To reduce the risk of electric shock, unplug the power pack from the outlet before attempting any
instructed servicing.
• Have servicing performed by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the product is maintained.
• When charging a device, the product may feel warm. This is a normal operating condition and
should not be a cause for concern.
• When charging the internal battery, work in a well-ventilated area and do not restrict ventilation in
any way.
• Do not clean the product with harmful chemicals or detergents.
• Misuse, dropping, or excessive force may cause product damage.
• When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical
systems separate from each other.
• Do not use or store this product in direct sunlight for a long period, such as in a car, cargo bed, or
any other place where it will be exposed to high temperatures. Doing so may cause the product to
malfunction, deteriorate, or generate heat.
• Servicing of batteries should be performed or supervised by personnel knowledgeable about
batteries and the required precautions.
• Do not use this product near strong static electricity or strong magnetic fields.
• Do not expose this product to flammable, explosive gas, or smoke.
• Do not stand on the product.
• Do not immerse the product in water. If the product accidentally falls into water, place it in a safe,
open place and keep it away from fire until it is completely dry.
09 EN
General Instructions Regarding Removal and Installation of Batteries
• When replacing batteries, replace with the same type and number of batteries or battery packs.
• Do not dispose of batteries in a fire. The batteries may explode.
• Do not open or damage batteries. Released electrolytes may be toxic and are harmful to skin and eyes.
• A battery can present a risk of electrical shock and high short-circuit current. The following precautions
should be observed when working on batteries:
a) Remove watches, rings, or other metal objects.
b) Use tools with insulated handles.
c) Wear rubber gloves and boots.
d) Do not lay tools or metal parts on top of batteries.
e) Disconnect the charging source prior to connecting or disconnecting battery terminals.
f) Determine if the battery is inadvertently grounded. If inadvertently grounded, remove the source from
the ground. Contact with any part of a grounded battery can result in electrical shock. The likelihood of
such shock can be reduced if such grounds are removed during installation and maintenance (applicable
to equipment and remote battery supplies not having a grounded supply circuit).
Warning:
• Replacing a battery with an incorrect type may nullify safeguards and create danger;
• Disposal of the battery/product in a fire, a hot oven, or another source of significant heat, or by mechanically
crushing or cutting the battery/product may result in an explosion;
• Leaving the battery/product in an extremely hot environment may result in an explosion or leakage of
flammable liquids or gases;
• Subjecting the battery/product to extremely low air pressure may result in an explosion or leakage of
flammable liquids or gases.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
Attention
Not permitted on aircraft.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance with Directives 2014/53/EU &
2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://www.anker.com.
The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany
This symbol means the product must not be discarded as household waste, and should be delivered
to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural
resources, human health, and the environment. For more information on the disposal and recycling
of this product, contact your local municipality, disposal service, or the shop where you bought this
product.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
and any use of such marks by Anker Innovations Limited is under license. Other trademarks and
trade names are those of their respective owners.
EN 10