Publicidad
3. To deepen the cut, begin by turning the cutter depth screw 1/4 turn to the
right using a Phillips screwdriver (Figure 4-14).
4. Replace the cover and run an envelope through to verify if it has been cut.
5. Repeat steps 3 and 4 until the envelopes are being cut open. If you find the
cut is too deep, turn the screw to the left in 1/4 turn or smaller increments
until you have the envelope being cut without cutting the contents.
48
Omation® Series 210™ Envelopener® Operator Manual
Turn right in 1/4 turn
increments for a deeper cut
Figure 4-14: Adjusting the cutter depth
OPEX Corporation
Operation
Publicidad
