Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
1. Press Power Button to turn off; display will not be illuminated.
Squeeze Beater Eject Trigger to remove Beaters or Whisk before
cleaning.
2. Twisted Wire Beaters and Whisk attachment are dishwasher-safe,
or wash in hot, soapy water; rinse and dry.
Troubleshooting
Hand Mixer is working very slowly.
• Too many ingredients in bowl. Remove some ingredients and
restart.
• Speed Control Dial is set too low. Turn Speed Control Dial clockwise
to increase speed.
Why are Beaters or Whisk falling out?
• Beater hasn't been fully inserted. Make sure Beaters are installed
according to icons on bottom of Mixer and click into place.
w WARNING
Electrical Shock Hazard.
• Disconnect power before cleaning. Do not immerse mixer, cord,
or plug in any liquid.
• Disconnect charging plug from charging port before cleaning.
w CAUTION
Always turn mixer off with the power button before
inserting or removing beaters or whisk.
3. Wipe Base with a clean, damp cloth.
NOTE: Do not use abrasive cleaners or scouring pads. To reduce the
risk of electrical shock, do not immerse Hand Mixer in water at any
time.
Hand Mixer will not start.
• Ensure all steps to charge Hand Mixer are completed. 1. Press
Power Button 2. Press Speed Control Dial 3. Turn Speed Control
Dial.
• Hand Mixer is charging. When charging, Mixer cannot be used.
• Make sure Hand Mixer is fully charged, then press Power Button.
Press center of Speed Control Dial and turn Speed Control Dial to
desired speed.
Hand Mixer is not charging.
• Check to see if Power Adapter is securely plugged into an electrical
outlet of proper voltage and frequency. Next, ensure Charging Plug
is inserted into Charging Port on Hand Mixer.
• Power Adapter is not plugged into wall outlet, or circuit breaker is
tripped. Plug into outlet and check function of outlet.
7
Publicidad
