Descargar Imprimir esta página

Ryobi PBLHV704 Manual Del Operador página 9

Limpiador de manchas de tamaño mediano one+ hp swiftclean de 18 v

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
If product is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, take it to
a service center prior to continuing use.
WARNING:
Have servicing performed by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the product is maintained.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING AND STORING THE SPOT
CLEANER
See Figures 10 - 12, page 11.
 Remove the battery pack.
 Place the unit on a level surface.
CAUTION:
If the recovery tank contains liquid, do not turn the unit
upside down as it may enter the motor.
To clean the recovery tank:
 Slide the tank release lever on the recovery tank. While
holding the lever use the handle on the tank to pull away
to release.
NOTE: ILLUSTRATIONS START ON PAGE 10 AFTER
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
 Place the recovery tank on a level surface. Use the tabs
to remove the lid of the tank.
 Move the recovery tank over a suitable container or drain.
 Empty the contents and rinse the tank.
To clean the solution tank:
 Remove the solution tank as described earlier in the
manual.
 Unscrew the cap and empty any excess formula.
 Rinse the tank and cap.
 Replace the cap and reattach the solution tank.
To clean the hose:
 Remove the hose and wide path nozzle from the storage
clips.
 Depress the latch on the wide path nozzle and remove it
from the hose.
 Attach the hose rinse tool to the end of the hose.
 Insert the battery pack.
 Press the ON/OFF button to start the spot cleaner.
 Press the spray trigger for 30 seconds.
NOTE: The clean water will rush through the hose, ef-
fectively cleaning any leftover dirt & debris from the hose.
 Press the ON/OFF button to stop the spot cleaner.
 Repeat as needed until the hose is cleaned.
 Remove the battery pack.
 Remove and empty the recovery tank.
 Clean recovery tank, wide path nozzle, and brush insert.
Note: Warm water and mild soap can be used to clean.
 Make sure all parts are dry before reassembly.
 Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents.
STORING THE SPOT CLEANER
 Remove the battery pack.
 Remove, rinse, and dry the solution tank and the recovery
tank, if necessary.
NOTE: Allow 24 hours for parts to dry completely.
 Install both tanks onto the unit.
 Store the unit in a dry place out of the reach of children.
 Store the battery in a separate location and out of the
reach of children.
9 — English

Publicidad

loading