DeWalt DCN692M1 Manual De Instrucciones página 11

is no battery pack in the cavity. Unplug the charger
before attempting to clean.
6. Do not freeze or immerse the charger in water or any
other liquid.
Storage Recommendations
1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
The DCN692 cordless framing nailer has been designed for
driving nails into wooden workpieces.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This cordless framing nailer is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
TOOL SPECIFICATIONS
Firing Mode selective: Bump or sequential
Voltage
Height
Width
Length
Weight
Magazine Angle
Loading Capacity
NAIL SPECIFICATIONS
Nail Lengths 2"– 3–1/2" (50 mm–90 mm)
Shank Diameters .113"–.131" (2.8 mm–3.3 mm)
Nail Stick Angles
Shank Types
20
13.5" (346 mm)
4" (104 mm)
13.25" (335 mm)
8.0 lbs. (3.63 kg)
33°
Up to 55 nails
Clipped Head or Full Head
30°– 34°
Smooth and Ring
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Read the section titled Nailer Safety
Warnings at the beginning of this manual. Always
wear eye and ear protection when operating this
tool. Keep the nailer pointed away from yourself and
others. For safe operation, complete the following
procedures and checks before each use of the nailer.

WARNING: If the tool has been dropped or you
suspect tool damage perform tool operation check as
defined in the Mode Selection section of the manual.
If it doesn't perform according to the manual, stop
using the tool and have it serviced at an authorized
D WALT service center.
e
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack from tool.
3. Lock the pusher in the back position and remove all nail
strips from the magazine.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use a tool
that has the contact trip restrained in the up position.
5. nEVER use a tool that has damaged parts.

WARNING: To reduce the risk of personal injury,
disconnect battery pack from tool before performing
maintenance, clearing a jammed nails, leaving work
area, moving tool to another location or handing the
tool to another person.
Installing and Removing the Battery Pack
(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 12
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 15 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
English
into the tool handle, align the
9