Publicidad
Idiomas disponibles
Idiomas disponibles
2. Load the staples into the magazine. Then close the magazine by pushing it fully upward.
3. Check that the air supply pressure is in the range of
device connector. The device is ready for use. Press the gun head against the workpiece to be fixed and
squeeze the trigger to fire the staple.
3.3.
Cleaning and maintenance
a)
Disconnect the device from the compressed air supply before any cleaning, adjustment, or replacement
of accessories, and if the device is not in use.
b)
Use only non-corrosive cleaning agents for cleaning surfaces.
c)
After each cleaning, all parts should be thoroughly dried before the device is reused.
d)
Store the appliance in a dry and cool place protected from moisture and direct sunlight.
e)
Perform regular inspections of the unit checking technical fitness and any damages.
f)
Use a soft cloth for cleaning.
g)
Lubricate the gun by applying 2-3 drops of oil designed for air tools to the air inlet every day.
h)
Keep the device clean.
i)
Every month or every 50 hours of use, remove the top plate covering the striking pin and clean it.
j)
Use a water separator in the compressor line to reduce moisture contamination and possible corrosion
damage to the tool.
Disposal of used units.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by the
symbol on the product, operating instructions, or packaging. The materials used in this appliance are
4.14 - 6.89
bar. Connect the pressure hose to the
Publicidad
