Hilti DX 351-CT Manual De Instrucciones Original página 26

4.2 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Min. distance to edge
(base-material edge to fastener)
Min. center-to-center distance
(between fasteners)
Min. base material thickness
4.3 Product properties (extensions)
Weight (grip section)
Weight (extension, 1 ft)
Weight (extension, 3 ft)
Length (grip section)
Length (short extension)
Length (long extension)
4.4 Noise and vibration information
General conditions for noise measurements
The noise values listed were determined under the following conditions:
Boundary conditions:
cartridge
Energy setting
Application
Technical data, noise and vibration values
Noise information
Sound power level (L
WA
Sound pressure level (L
Peak sound pressure level (L
Total vibration
The value that must be specified in accordance with 2006/42/EC
does not exceed the limit value of:
5 Preparations at the workplace
▶ Before you start driving fasteners, always check that you are using the correct combination of fastener
guide, piston, fasteners and cartridge.
▶ Before commencing work, check that all safety devices are fitted and that they are functioning correctly.
In order to ensure faultless operation of the fastening tool, all parts must be fitted correctly and must
meet the necessary requirements.
20 English
Concrete
≥ 70 mm
≥ 80 mm
≥ 100 mm
DX 351-CT
0.9 kg
0.2 kg
0.5 kg
935 mm
288 mm
915 mm
Caliber 6.8/11 red
3
Fastening 0.75 mm sheet steel to concrete (B35) with X­U 27 P8
)
)
pA
)
pC,peak
Steel supporting structures
≥ 15 mm
≥ 20 mm
Follow the instructions in the
operating instructions of the
fastener!
DX 351-CT
110 ±2 dB
97 ±2 dB
127 ±2 dB
< 2.5 m/s²
400914
*400914*