Midea MRF29D3ABB Manual Del Usuario página 16

Filter element time reset
• Hold down
At this time, the FILTER the element data is cleared.
Celsius transformation
• Long press the
function.
Forcing AP mode
• Long press
refrigerator to AP mode and display AP in the temperature display area. After
the module enters AP mode successfully, it automatically exits AP mode, and
the temperature display area restores to normal temperature display.
Sabbath mode
• Press simultaneousl the
Sabbath mode.
• If the refrigerator is connected to the Internet, you can enter or exit the
Sabbath mode through the corresponding function buttons in the Smart Home
refrigerator control interface, and the APP can select the automatic exit time.
• 6s after entering the Sabbath mode lock, the display goes out, the buzzer does
not sound, the door opening lamp does not light up, and the distributor only
EN
displays the selected function in low brightness.
• When the APP terminal enters the Sabbath function, the APP terminal may
send a command to turn o the ice maker function at the same time.
Anti-condensation heating element on/o
• Press the
press the button
function is successfully set.
• Under the above settings, unlock and enter again, continue to press the and
release the anti-condensation heating element o function.
Open door prompt sound switch
• At the same time, press
tone.
ATTENTION
• If the rear door is not closed after power-on, the APP or machine will give an alarm, call
three times after exceeding 2 minutes, and then add one alarm every 1 minute.
for 3 seconds to perform the "RESET FILTER" function.
3S to achieve Celsius Fahrenheit conversion
for 3s to forcibly set the wireless network module of the
and for 4 seconds, the Hua Celsius icon flashed, and then
, and the anti-condensation heating wire shutdown
for 4s, the Hua Celsius icon no longer flashes, press the button to
and
and for 3s to enter or exit the
mode.
button 4s, close or open the door prompt
16