CASO DESIGN IP 3500 Pro Manual De Instrucciones página 39

14.1 Operating elements and displays
14.1.1 Operating panel and Display
1 Display of the selected setting
2 Selection button (-), reduction of the power level, temperature or duration
3 Selection button (+), increase of the power level, temperature or duration
4 Button Keep Warm
5 Button Level
6 Button Temperature (Temp.)
7 Button Timer
8 On/Standby button
14.1.2 Details on the device
This instruction and when "H" is displayed, is to warn that the ceramic hob may
still be hot. Although the induction cooker itself does not generate any heat
during the cooking process, the temperature of the cooking utensil does heat the hob!
ATTENTION Risk of burning due to hot surface!
Adhere to the following safety instructions in order to avoid being burnt by the hot
appliance:
► Do not touch the surface of the ceramic hob while it is still hot ("H" is displayed)
► Do not place any objects on the hot ceramic hob.
14.1.3 Signal Tones
The appliance emits an acoustic signal after being switched on and in the event of a fault.
14.1.4 Overheating Protection Facility
The appliance is equipped with an overheating protection facility. If the temperature of the
appliance exceeds the critical limit the error message "E05" is displayed. For safety
reasons the appliance shuts off further power supply. After the cooling-down phase the
appliance can be switched off and then back on again.
► You will find more detailed information on error messages in the chapter entitled
„Fault indications".
14.1.5 Rating plate
The rating plate with the connection and performance data can be founded on the back of
the device.
Please note
39