Asus V6-Serie Manual De Instalación página 5

Selecting the voltage
The system's �o�er su��ly unit has a 115
V/230 V voltage selector s�itch located
beside the �o�er connector. Use this
s�itch to select the a��ro�riate system
in�ut voltage according to the voltage
su��ly in your area.
If the voltage su��ly in your area is
100-127 V, set the s�itch to 115 V.
If the voltage su��ly in your area is
200-240 V, set the s�itch to 230 V.
NOTE: Refer to the system User Guide for the exact location of the voltage selector.
Removing the side cover and
front panel assembly
1. Remove the cover scre�s on the rear �anel.
2. Pull the side cover to�ard the rear �anel until its hooks disengage from the
chassis tab holes. �et the side cover aside.
3. Locate the front �anel assembly hooks, then lift them until they disengage
from the chassis.
4. ��ing the front �anel assembly to the right, until the hinge-like tabs on the
right side of the assembly are ex�osed.
5. Remove the front �anel assembly, then set aside.
Air duct duct
2
Chassis tab holes
1
1
2
Installation manual
3
4
4
3
4
3
4