Haiger GDZ22-1 Manual Del Usuario página 13

Select a suitable location for the dryer on a hard even surface away from direct
sunlight or heat source e,g. radiators, baseboard heaters, cooking appliances etc,
Any floor unevenness should be corrected with the leveling legs located on the
bottom of the dryer.
TooMs and MateriaMs Required
Phillips head and flathead screwdrivers
Channel-lock adjustable pliers
1/2 inch open end wrench
Carpenter's level
Measuring tape (12ft, min,)
Duct tape
Rigid or flexible metal 4 inch (10,2 cm) duct
Vent hood
EMectriea_ Requirements
Power Supply:
3 or 4 wire, 240 Volt, 30 Amp, 60Hz, I Phase
Power Supply Cord Kit: (not supplied when sold in the United States)
The dryer MUST employ a 3-conductor power supply cord NEMA 10-30
type SRDT rated at 240 Volt AC minimum, 30 Amp., with 3 open end
spade lug connectors with upturned ends or closed loop connectors and
marked for use with clothes dryers. If being installed in a manufactured
(mobile) home, the dryer MUST employ a 4-conductor power supply cord
NEMA 14-30 type SRDT or ST (as required) rated at 240 Volt AC
minimum, 30 Amp., with 4 open end spade lug connectors with
upturned ends or closed loop connectors and marked for use with clothes
dryers. See Electrical Connections for A 4-Wire System.
Unpaekin 9 Your Dryer
1, Remove all packaging material. This includes the foam base and all
adhesive tape holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packaging, tape or printed
materials before using the dryer.
12