Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLy
LOOSE PARTS
See Figure 4, page 18.
The following items are included with the cut-off machine:
Arbor Wrench ............................................................... 1
14 in. Abrasive Wheel ................................................... 1
Operator's Manual (not shown)
UNPACKING
This product has been shipped completely assembled.
Carefully lift machine from the carton by the carrying
handle and the machine base, and place it on a level
work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
This machine has been shipped with the machine arm
secured in the down position. To release the machine arm,
push down on the "D" handle and unhook the transport
chain.
Lift the machine arm by the handle. Hand pressure should
remain on the "D" handle to prevent sudden rise upon
release of the transport chain.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
The machine is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing, do not oper-
ate this tool until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acci-
dental starting and possible serious personal injury.
WARNING:
A 14 in. wheel is the maximum wheel capacity of the
cut-off machine. Never use a wheel that is too thick
to allow outer flange to engage with the flats on the
spindle. Larger wheels will come in contact with the
wheel guards, while thicker wheels will prevent the
bolt from securing the wheel on the spindle. Either
of these situations could result in a serious accident
and can cause serious personal injury.
MOUNT TO A WORK SURFACE
See Figure 5, page 19.
The saw should be mounted to a firm supporting surface
such as a workbench. Bolt holes have been provided in
the saw base for this purpose. Each of the mounting holes
should be bolted securely using machine bolts, lock wash-
ers, and hex nuts (not included). Bolts should be of sufficient
length to accommodate the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all bolts
securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
9 - English
Publicidad
