Publicidad
Idiomas disponibles
Idiomas disponibles
Remaining Capacity LED Indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
WARNING
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack
and the red Indicator light is "blinking". When the battery pack temperature returns to
between 0°C (32°F) and 50°C (122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is
defective. Please contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C (32°F) or above
40°C (104°F)
6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in
the room for one hour to warm up before starting the battery pack.
7. R emove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.
8. TOOL OPERATION
Lock instruction of use
Press lock knob while pressing down the main switch.
Then release the main switch to keep the tool in operation.
Press the main switch again to unlock and stop
tool operation.
Remove and place the pad
1. Press the spindle lock button.
2. R otate until it is fixed.
RC Status
0%-25%
26%-50%
51%-75%
76%-100%
Switch lock knob
1
2
•
9
•
1
2
Publicidad
