Troubleshooting
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
warranty.
– Problem
• Solution
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly/
No reaction to operation of any of
the controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Use of incompatible cassette types (METAL
or CHROME)
I) for recording
• Only use NORMAL (IEC
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3 materials: cardboard,
paper pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe
the local regulations regarding the disposal of packaging, dead batteries and old equipment..
no disc indication
– No CD inserted
• Insert a CD, CD-R or CD-RW
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R is blank or the disc is not finalized
•Use a finalized CD-R
CD playback does not work
– CD badly scratched/ dirty
• Replace/ clean CD (see maintenance)
– Laser lens steamed up
• Wait until lens has adjusted to room temperature
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– Program is active
• Quit Program mode(s)
EN-9
SPECIFICATION
Specifications :
GENERAL
Power supply
Power consumption
Dimensions of unit
Frequency range
AUDIO SECTION
Output Power (RMS)
Speaker
Specification subjects to be changed without notice.
Do not dispose of this product in the usual household garbage at the end of
Do not dispose of this product in the usual household garbage at the end of
its lifecycle; hand it over at a collection point for the recycling of electrical
its lifecycle; hand it over at a collection point for the recycling of electrical
and electronic appliances. The symbol on the product, the instructions for
and electronic appliances. The symbol on the product, the instructions for
use or the packing will inform about the metthods for disposal.
use or the packing will inform about the metthods for disposal.
The materials are recyclable as mentioned in this marking. By recycling,
The materials are recyclable as mentioned in this marking. By recycling,
material recycling or other forms of re-utilization of old appliances, you are
material recycling or other forms of re-utilization of old appliances, you are
making an important contribution to protect our environment.
making an important contribution to protect our environment.
Please inquire at the community administration for the authorized
Please inquire at the community administration for the authorized
disposal location.
disposal location.
ALL RIGHTS RESERVED
COPY RIGHT DENVER ELECTRONICS A/S
www.denver-electronics.com
: AC 230V~50Hz
: 14 Watts
: 230(W) X 231 (H) X161 (L) mm.
: FM 88 - 108 MHz.
: 2 x 1W R.M.S.
: 8 Ohms
EN-10