Publicidad
Idiomas disponibles
Idiomas disponibles
Indirect measurements
Indirect measurements: determining a distance using two measurments. In
order to obtain a height measurement, for which you will need two or three
measurements, proceed as follows:
Pres the key
once for the symbol
Aim at the highest point (1) and carry out your measurement. The first
value is saved. Hold the meter as steadily as possible and set it down evenly
on the ground so that it rests on the bottom two edges.
Press the measuring key again to measure the horizontal distance. The
result of this measurement is displayed in the second line, while the total sum
is displayed in the bottom line.
Indirect measuring – calculating a distance using three measuring
values
Press the key
2x; the symbol
pears on the display.
Aim at the lowest point (1) and carry out
your measurement. The first value is saved.
B - 7
to appear.
ap-
Operating Manual – Laser Distance Meter BD 10
Hold the meter as steadily as possible.
The exact position of the two bottom edges
must remain unchanged throughout!
Now point the laser at the horizontal tar-
get point (2) and carry out your measurement.
The result is displayed in the second line.
Finish by aiming at the top point (3) and pres the
key
to carry out measuring (3). The result is presented in the bottom line
while the partial result is displayed in the second line.
History
The last 20 values (measurements or calculations) are displayed in the
reverse order. Use the keys
to navigate through the saved values.
or
which are reserved for this purpose
EN
Publicidad
