Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Table Boards
1. Locate the following parts and hard-
ware:
4 Screw Pan Hd 1/4-20 x 1-1/4
8 Washers 17/64 x 5/8 x 1/16
4 Lockwashers 1/4
4 Screw Pan Hd Ty "AB" #8 x 3/4
4 Hex Nuts 1/4
2 Tables (Particle Board)
(Layout marks not shown)
2. Position the tables on the assembled
legstand. Make sure the counterbored
holes are facing up and closer to the
outside.
3. Place two pan head screws 1/4-20 x
1-1/4 through flat washer through the
table(s) and then legstand. Secure
with flat washer, lockwasher and hex
nut as shown. Finger tighten only.
4. Place a straightedge or flat board
against the 8" edge of the table boards
to align the two table boards. For the
narrowest width maintain 4 inches
between the table boards. Maintain 6
inches for the middle width and 8
inches for the widest width.
All manuals and user guides at all-guidesbox.com
17/64 x 5/8 x 1/16
4
6"
8"
12
Screw Pan Hd. 1/4-20 x 1-1/4
Washer
Screw Pan Hd
Ty "AB" #8 x 3/4
Table
"
Lockwasher 1/4
Hex Nut 1/4
Straightedge
Publicidad
