Publicidad
Idiomas disponibles
Idiomas disponibles
the collet and installing accessories on the mini
drill (see assembly the accessories). To lock the
spindle, rotate the collet until the hole n the shaft
is aligned with the hole in the flexible shaft collar
(a) (see Fig K). Insert the Soft Shaft Wrench
through the holes to lock the shaft.
Note: Do not attempt to loosen or tighten the
collet without locking the shaft as noted above.
Damage to the flexible shaft will result.
OPERATION
1. SWITCH ON / OFF (SEE FIG F)
NOTE: This tool
has been set to
the slowest speed
before switching
on.
to start the tool,
F
press the on/off
switch to "I" ON
position. to stop, press the switch to "O" OFF
position.
2. SpEED ADjuSTMENT (SEE FIG G)
o achieve the
best result
when working
with different
materials, you
can adjust the
G
tool speed. It is
adjustable from
10000 to 32000rpm.
The tool has a variable speed control for precise
speed adjustment. Set it to the required speed
for operation.
NOTE: Select a low speed when working with
wood, plastics and polishing.
Generally, select higher speed for small tools
while lower speed for larger tools.
From number "1" to "MAX", the speed is
corresponding from 10000 to 32000rpm.
3. DrILLING OpErATION
Turn the tool on until full speed. Apply the tool
to the workpiece gently. to obtain a good finish,
move the tool in the leftward direction slowly.
NOTE: Apply light pressure on the tool.
Excessive pressure will only cause a poor finish
and overloading of the motor.
4. HOLDING THE TOOL
For milling or engraving, hold the tool like a pen.
Take care not to cover the ventilation slots.
NOTE: The tool will get warm during normal
operation. Observe the rated operating time.
USING ACCESSORIES
the chart below lists the description, use speed
and scope for some of the small articles supplied
together with the tool by category. To achieve
best performance of the tool, it is strongly
recommended that you read it prior to operation,
failure to adhere to this may cause accessories
to fail.
NOTE: ALWAyS Wear eye protection Insert the
shaft FULLy into the collet. Use ONLy up to the
speeds stated below.
39
Publicidad
