[Auto] - Panasonic Lumix DMW-FL360 Instrucciones De Funcionamiento

[AUTO]

Press the [MODE] button, and select
the flash mode. (P26)
1 Press the [ZOOM] button
to set the zoom value to
the focal length of the lens.
2 Press and hold the
[MODE] button and then
turn the select dial within
2 seconds to set the ISO
sensitivity.
≥
The unit will switch to the function
settings if the [MODE] button is
pressed for more than 2 seconds.
(P37)
3 Turn the select dial and set
it to the aperture of the lens.
≥
If the combination of the ISO
sensitivity and aperture are
outside the usable range, a
warning is given in the form of the
flashing ISO sensitivity and
aperture displays. In a case like
this, change the ISO sensitivity
and aperture.
4 Press the shutter button
all the way down, and take
ZOOM
the photo.
5 Check that the [AUTO
CHECK] lamp is flashing.
MODE
≥
If the [AUTO CHECK] lamp
continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does
not flash, the unit has not fired
successfully. Check the settings
on the unit and the digital camera
and then take the picture again.
≥
The flash intensity can be adjusted
in 1/3 steps by varying the ISO
sensitivity and aperture from the
digital camera settings.
AUTO CHECK
27
VQT1B11