DHC BT797 Manual De Instrucciones página 10

SYSTEM TEST:
1. Select "SYSTEM TEST" from the main menu.
2. Turn off all vehicle accessory loads such as light,
air conditioning, radio, etc. Before starting the
engine.
3. When the engine is started, one of the three results will be displayed along
with the actual reading measured.
CRANKING VOLTS NORMAL
The system is showing normal draw. Press
«ENTER» to perform the charging system test.
VOLTS BEIM ANLASSEN LOW
The cranking voltage is below normal limits,
troubleshoot the starter with manufacturers
recommended procedure.
VOLTS BEIM ANLASSEN NOT
DETECTED
The cranking voltage is not detected.
4. Press «ENTER» to begin charging system test.
PRESS ENTER
FOR CHARGING
TEST
5. Press the «ENTER» key, one of the three results will be displayed along with
the actual reading measured.
10
10
10
SYSTEM TEST
xx.xx V
TURN OFF LOADS
START ENGINE
CRANKING VOLTS
xx.xx V NORMAL
CRANKING VOLTS
xx.xx V LOW
CRANKING VOLTS
NOT DETECTED
MAKE SURE ALL
LOADS ARE OFF