GE APWD07 Manual Del Propietario Y Instrucciones De Instalación página 12

Installation Instructions
UNPACK AIR CONDITIONER
1.
Excessive Weight Hazard
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other injury.
• Remove packaging materials. Save the carton and
the foam packaging for storing the air conditioner
when not in use.
NOTE: There are NO packing materials inside the air
conditioner to remove—Do Not open the cabinet.
• Properly dispose of/recycle all packing material.
• Handle the air conditioner gently.
• Keep the air conditioner upright and level. Do not
set the air conditioner on its side, front, back or
upside down.
2. Pre-assemble: Exhaust Hose and
Window Bracket Panel Adaptor
1. After pre-assembly.
Note: To install nozzle and adapter to hose,
expanded both ends of the hose fully, the turn
clockwise to screw onto hose.
12
WARNING
Assemble Exhaust Hose
3.
Assembly and Mount to Back
of Unit
Extend the exhaust hose approximately 4" from
each end. Screw the adapters onto the ends of the
the round adapter into the exhaust vent on the back
of the Air Conditioner and turn counter-clockwise to
secure it.
Install Exhaust Nozzle to Main
4.
Window Panel
1. Hold the main
window panel so
that the L-shaped
edges of the
panel are facing
you.
2. Align the exhaust
nozzle with the slots in
the opening, and then
insert and slide the
nozzle to access the
hole from the back of
the main window panel.
3. Turn the main window
panel over, so that
the nozzle is away
flat tip screw through
the hole to fasten the
window panel to the
adapter.
49-5000544 Rev. 3