Caso Germany WineSafe 18EB Manual De Instrucciones página 40

13.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Wine refrigerator do not operate.
Wine refrigerator is not cold enough.
The light does not work.
Vibrations.
The wine refrigerator seems to make to
much noise
The door will not close properly.
LED could not display.
LED display error - Lo
Bottoms are not functional.
Compressor will not start
Compressor re-start
caso Wine Safe 18EB
Possible Cause
Not plugged in using different voltage. The
circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher
setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
Check the service center.
Check to assure that the wine refrigerator is
level.
The wine refrigerator is not level.
The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak.
The shaves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the service
center.
Temperature controller panel is damaged.
Room temperature is lower
temperature.
Compressor will stop working when cooling
system in the cabinet reaches
temperature, and re-start working until the
desired temperature is achieved. Allow a
minimum 5 minute interval before re-starting.
than desired
presetting
40