Maintenance
For maximum performance
It is important to lubricate regularly to get maximum performance
and trouble-free operation. The motor should be lubricated with
oil; i.e. drops of oil can be dropped either into the compressed air
or directly into the air inlet.
The trigger, planetary gears, needle bearings and ball bearings
should be lubricated with grease during the regular overhaul of
the machine.
The angle gear and clutch must be lubricated using grease that
contains molybdenum disulphide: Molykote BR2 Plus, for ex-
ample, or an equivalent brand.
Use lubricants of good quality. The oils and greases mentioned
in the table are examples of lubricants which are recommended.
Rust protection and internal cleaning
Water in the compressed air, dust and wear particles cause rust
and sticking of vanes, valves etc. An air filter should be installed
close to the machine (see "Air quality").
Service instructions
Overhaul and preventive maintenance is recommended at regular
intervals once per year or after maximum 250.000 tightenings de-
pending on which occurs sooner. More frequent overhaul may be
needed, if used at high torque and long tightening times. If the
EN
machine not is working properly, it should immediately be taken
away for inspection.
The strainer at the air inlet and the exhaust silencer should be
cleaned frequently or replaced in order to prevent clogging, which
decreases the capacity.
At the overhauls, all parts should be cleaned accurately and de-
fective or worn parts (i.e. O-rings, vanes) should be replaced.
Disassembling / assembling
It is important that the machines threaded connections are tightened
properly; i.e. in accordance with the specifications on the exploded
views.
A
Lubricate o-rings and threaded connections with grease before
assembling.
Cleaning
Clean all parts thoroughly in white spirit or similar cleaning agent.
To prevent clogging and decreased power, it could be necessary
to clean the strainer (if used) and the exhaust filter between the
overhauls.
Inspection
After the cleaning, inspect all parts. Damaged and worn parts
should be replaced.
Lubrication
Lubricate specially gears, valve and clutch with grease containing
molybdenum disulphide (e.g. Molykote BR2 Plus). Please see
exploded views and fig. under Service instructions.
Grease guide Nutrunners
Brand
Bearings
BP
Castrol
Spheerol EP L2
Esso
Beacon EP2
Q8
Rembrandt
EP2
Mobil
M.Grease XHP
222
Shell
Alvania EP2
Texaco
Multifak EP2
Molycote
Lubricating
STP
Brand
Bp
Castro
Esso
Q8
Mobil
Shell
Texaco
Molycote
Part no
8940164681
Issue no
0
Series no
1
Date
2008-06
Page
7
Free wheel
unit (gear rim
and gear
wheels)
Energrease LS-
EP2
Beacon EP2
Rembrandt
EP2
Alvania EP2
Suntemp LE
9102
Oil treatment
Gears
General purpose
Energrease LS-EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP
222
Alvania EP2
Multifak EP2
BR2 Plus
Free wheel