Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USE
PREPARATION
•
Your device has a pusher under the coil that allows you to adjust the length of the cutting wire, it is
located under the machine, as indicated by the arrow on the diagram above. Your cutting wire must
have the right length, for optimal use, and must therefore come close to or even touch the blade of
the cut wire (8), located under the housing (6).
•
If the cutting wire is not on the right length, then you need to adjust it. While having the machine
disconnected, press the pusher under the coil and with gloves, pull the ends of the cutting wire to
extend it. If during use you want to lengthen the cutting wire, you can press the pusher by pressing
the coil on the ground, the wire will then lie down and cut it to the right length..
1
2
Insert the power outlet into the electrical extension previously passed into the support as explained in
the 'assembly' section.
36
30/03/2023
Publicidad
