Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Features and appearance will vary.
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light will blink and "Pause" will display.
To continue the cycle, press Start again.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will show the dryer status:
Pause
(on some
models)
Controls
Sensing
Clean Lint
Filter
Control Lock
D
You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have
started a cycle. Children cannot accidentally start the dryer by touching buttons with this option selected.
To lock/unlock the dryer controls, press and hold the Wrinkle Care and Less Time buttons for 3 seconds.
The control lock icon will flash while locking/unlocking, stay on when locked, and turn off when unlocked.
NOTE: The Power button can still be used when the machine is locked.
6
A
Mixed Load
Delicates
Normal
Cottons
Sanitize
Active Wear
B
The Start/Pause light will flash and the message "Pause" will show in the display when
the dryer's cycle is paused. The cycle may be re-started by pressing the Start button.
The dryer is locked - will blink once if you press any button or turn the cycle knob.
Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining.
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
E
C
Quick Dry
Towels
90 min
60
Bulky
40
Bedding
Pause
Controls
Air Fluff
20
Sensing
10
Clean Lint Filter
Timed Dry
Time
H
C
I
Delay
Drying
Cooling
Done
More Dry
High
Dry
Medium
Less Dry
Low
Damp
No Heat
Level
Temp
G
D
H
H
F
H
49-3000344 Rev 2
Publicidad
