• Opening the cooling device for long periods
can cause significant increase of the temperature
in the compartments of the device.
• Clean regularly surfaces that can come in contact
with food and accessible drainage systems.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold develop-
ing within the device.
A
NOTICE!
Damage hazard
• Check that the voltage specification on the data
plate corresponds to that of the energy supply.
• Only connect the cooling device as follows:
– With the DC connection cable to a DC power
supply in the vehicle
– Or with the AC connection cable to an AC
power supply
• Never pull the plug out of the socket by the
cable.
• If the cooling device is connected to a DC outlet,
disconnect the cooling device and other power
consuming devices from the battery before con-
necting a quick charging device.
• If the cooling device is connected to a DC outlet,
disconnect the cooling device or switch it off
when you turn off the engine. Otherwise you
may discharge the battery.
• The cooling device is not suitable for transport-
ing caustic materials or materials containing sol-
vents.
• The insulation of the cooling device contains
flammable cyclopentane and requires special
disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate
recycling center.
• Do not use electrical devices inside the cooling
device unless they are recommended by the
manufacturer for the purpose.
• Do not place the cooling device near naked
flames or other heat sources (heaters, direct sun-
light, gas ovens etc.).
14
• Risk of overheating!
Ensure at all times that there is a minimum of
50 mm ventilation on all four sides of the cooling
device. Keep the ventilation area free of any
objects that could restrict the air flow to the cool-
ing components.
Do not place the cooling device in closed com-
partments or areas with none or minimal air flow.
• Ensure that the ventilation openings are not cov-
ered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against
heat and moisture.
• The device shall not to be exposed to rain.
Intended use
The cooling device is suitable for cooling food. The
cooling device is suitable for use in vehicles or on
boats.
The cooling device is designed to be operated
from a DC on-board power supply of a vehicle or
boat, a DC auxiliary battery or from an AC power
supply.
The cooling device is suitable for camping use.
The cooling device is intended to be used in
household and similar applications such as
• Staff kitchen areas in shops, offices and other
working environments
• Farm houses
• Clients in hotels, motels and other residential
type environments
• Bed and breakfast type environments
• Catering and similar non-retail applications
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage