Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 6

Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 2
å
Insert four WOOD DOWELS (42F) into the exact holes
shown in one BACK (E).
å
NOTE: You may need to gently tap the WOOD DOWEL in
with your hammer.
å
Fasten the RIGHT END (A) and RIGHT UPRIGHT (D) to
the BACK (E). Tighten six TWIST-LOCK® FASTENERS.
å
NOTE: Be sure the WOOD DOWELS in the BACK insert
into the END and UPRIGHT.
Page 6
FASTENER
®
If the TWIST-LOCK® FASTENER
is already inserted in the part,
be sure both the dowel end and
fastener edge are straight.
This hole must be here.
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
426285
i t h
e w
®
f a c
C K
S u r
- L O
I S T
E R S
T W
T E N
F A S
42F
A
f a c
S u r
I S T
T W
T E N
F A S
D
E
www.sauder.com/commercial-office/service
Dowel end
2
u t
i t h o
e w
®
C K
- L O
E R S
42F