Clatronic AKKU-SAUGER AKS 827 Manual De Instrucciones página 8

Attach the Charging Station to the Wall
Mount the charging station near a power socket.
1. Measure the distance between the two slotted holes of
the mount and drill two holes in the wall at this distance.
2. Insert the plugs into the wall.
3. Turn the screws into the plugs with a screwdriver so that
they protrude approx. 3 – 4 mm.
4. Hang the wall mount on the screws.
Charging the Built-in Battery
1. Switch off the appliance.
2. Connect the power supply unit to the connection socket.
If you have prepared the wall holder as a charging sta-
tion, hang the appliance in it.
3. Connect the power supply unit to an approved power
outlet. Charge the appliance for 6 hours before using it
for the first time.
- The indicator light lights up red during charging.
- The light gives no indication of the battery's charge
status.
- It is normal for the appliance to heat up during
charging.
4. Stop all other charging process after a maximum of
6 hours or once the indicator light lights up permanently
green.
CAUTION:
Always disconnect the mains plug from the socket after
charging.
Using the Appliance
1. Disconnect the appliance from the power supply unit.
2. Attach a nozzle if necessary.
3. Switch on the appliance with the switch.
End of Use
1. Switch off the appliance.
2. Empty the collection container as described below. Clean
the filter insert after each use to restore the appliance to
full performance the next time it is used.
3. Then recharge the accumulator of the appliance.
Maintenance and Cleaning
WARNING:
• Always disconnect the appliance from the power sup-
ply unit before maintenance and cleaning!
• Never immerse the motor housing in water for clean-
ing. It could cause an electric shock or fire.
8
AKS827_IM_04.2023
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use sharp or abrasive cleaning agents.
• The individual components are not suitable for clean-
ing in the dishwasher.
• Never wash the filter in the washing machine.
• The housing can be wiped clean with a slightly damp
cloth.
• You can wipe the power supply unit with a dry cloth.
Empty Collection Container
1. If necessary, remove the nozzle from the appliance.
2. Hold the appliance horizontally when removing the
collection container.
3. Press the button in front of the on / off switch to release
the collection container.
4. Pull the permanent filter out of the collection container.
5. Empty the components. Knock out the filter.
6. Put the permanent filter back into the collection con-
tainer.
7. Reattach the collection container to the motor housing:
- First place the collection container with the flattened
side at the bottom of the housing.
- Close the appliance by locking the collection container
into place at the top of the housing.
Collection Container, Permanent Filter,
Nozzle Attachments
• You can rinse these components under running water.
If required, you can also wash the components in warm
water, without adding detergent, using a soft brush.
• Allow the components to dry before you reassemble the
appliance.
Storage
• Clean the appliance as described and allow it to dry
completely.
• Always store the appliance out of the reach of children in
a well-ventilated and dry place.
• The storage temperature should be between 10 °C and
20 °C.
• We recommend storing the appliance in its original
packaging if you do not intend to use it for a long period
of time.
• Life of the rechargeable battery: Even when switched
off, the rechargeable battery discharges continuously.
If the appliance is out of use for a longer period of time,
charge the rechargeable battery at least once every
4 to 6 weeks.
19.04.23