Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Installing the spout assembly
□
Install the spout assembly (A) onto the
connector (S). Be sure the spout assembly (A)
is resting rmly on the deck.
□
Push down on spout assembly (A) and tighten
set screw (B) with the Hex wrench
(Hex: 2.38mm, C). Insert the index (T).
6
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (M) with the rubber washer (N), metal
washer (O) and mounting nut (P) through
the hole on the right (cold) side.
□
From above, thread the ange (K) onto the
valve body (M).
□
Tighten the mounting nut (P) using a basin
wrench, so that the ange (K) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (L)
on the left (hot) side.
A
T
C
B
S
5
Removing the mounting kits
□
Remove the protective caps (X).
□
Loosen the anges (K) from the valve bodys
(L & M). Adjust the rubber washers (N), metal
washers (O) and mounting nuts (P) to the
bottom of valve bodys (L & M).
L
5
Please contact 1-855-HD-GLACIER for further assistance.
X
X
K
K
L
M
N
O
P
N
O
P
K
M
N
O
P
HOMEDEPOT.COM
Publicidad
