Quick SBC ADVANCED Serie Manual Del Usuario página 13

EQUIPMENT NECESSARY FOR INSTALLATION
On the basis of the type of model, use the batteries and cables on the output terminals as specified
in the following table:
MODELLO
Battery voltage
Battery capacity
Minimum output cable size
The cables connected to the output terminals have a maximum length of 4 metres.
WARNING:
the battery charger must be used only with a re-chargeable lead/liquid
electrolytic batteries or lead/gel (sealed or non-sealed).
INSTALLATION SITE
Install the battery charger in a dry and ventilated place and as near to the batteries as possible.
The battery charger, although having high efficiency, develops a certain amount of heat during
functioning, therefore, it is imperative that the installation area has sufficient ventilation, enough to
allow use of the equipment at maximum power.
The battery charger can be installed in a horizontal or vertical position with cables coming out in
the downward position. The vertical position is recommended because the natural convection of
heat helps to cool the equipment. The perimeter of the battery charger (except the base) must be
kept at a distance from walls or objects by a minimum of 5 cm.
PART. B
CHARACTERISTICS AND INSTALLATION
SBC 300 ADV
SBC 300 ADV FR
140 ÷ 300 Ah
10 mm 2
SBC 500 ADV
SBC 500 ADV FR SBC 700 ADV FR
12 V
180 ÷ 400 Ah
16 mm 2
PART. A
SBC 700 ADV SBC 650 ADV
SBC 650 ADV FR
270 ÷ 600 Ah 140 ÷ 300 Ah
25 mm 2
GB
24 V
10 mm 2
FIG.1
13