Descargar Imprimir esta página

Hilti GTB 6X-A22 Manual De Instrucciones Original página 24

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 51
5.2
Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4
Fitting/changing the abrasive belt
CAUTION
Risk of injury! The abrasive belt can easily tear if the direction of travel is incorrect.
▶ Be sure to install the abrasive belt right way round for the direction of travel. The belt's direction of travel
must match the direction-of-travel arrow on the gear head.
1. Push the swing arm back toward the drive roller and hold it in this position.
2. If applicable, remove the abrasive belt.
3. Loop the new abrasive belt over the rollers.
4. Release the swing arm.
5. Check that the abrasive belt is fully seated on the rollers.
5.5
Fitting the side handle
1. Screw the side handle into the threaded socket.
2. The side handle can be screwed into the threaded socket on either side. Consequently, very awkward
places can be reached.
6
Operation
6.1
Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
➥ The motor runs.
3. Lock the on/off switch.
6.2
Setting belt speed
▶ Use the adjusting knob to set the belt speed.
6.2.1
Belt speed without load
Stage 1
Stage 2
Stage 3
Stage 4
Stage 5
Stage 6
18
English
2
3
3.8 m/s
4.3 m/s
4.9 m/s
5.9 m/s
7.2 m/s
8.4 m/s
2241319
*2241319*

Publicidad

loading